QU10317 NV4500 Roll Pin for 5th gear fork.

Need More Info? Use the handy Links below to access over 40 years of Dan’s product and vehicle specific Tech Notes to easily get the information you need for your vehicle’s repair, maintenance, or upgrade project!

Dan the Gear Man Tech Notes:
Special Tools

Tech Note 1: Special Tools
Need Torque Specs or Rebuild procedures? Order my 116 page, full color illustrated TM1003 NV4500 Rebuild Manual.

You will need some special tools to correctly service your NV4500 Transmission. The chart below lists our current NV4500 Special Tools for popular models.

TOOLS for SPECIFIC NV4500 MODELS
Component	23 Spline Dodge 4×4 NV4500LD	29 Spline Dodge 4×4 NV4500HD	30 Spline Dodge 4×2 NV4500LD	31 Spline Dodge 4×2 NV4500HD	32 Spline GM 4×4	35 Spline GM 4×2
Mainshaft Nut	QT2002	QT2001 QT2036	QT2002	QT2001 QT2036	QT2002 QT2028	1-1/2″ Hex Socket
Mainshaft Holding	NLA	QT2000	NLA	QT2011	N/A	N/A
5th Gear Nut Torx Cross Bolt	N/A	QT9205	N/A	QT9205	N/A	N/A
Output Seal Installer	N/A	QT1801	N/A	QT2058 CALL	Not Used	Not Used
Tailshaft Bushing Remover and Installer	Not Used	Not Used	Not Used	QT2044	Not Used	Not Used
TOOLS For ALL NV4500 MODELS
Countershaft Front Bearing Cup Installer	QT1802	Use with QT1101 or QT1119 Driver Handle. Also can use flat side to install Dodge 4×4 Rear Output Seal
Countershaft Front Bearing Installer	QT2004	Can also use to press 3-4 Synchro Hub on original equipment mainshafts
Input Bearing & Countershaft Rear Bearing Installer	QT2005	Can also use to install Input Seal
Input Bearing Cup Installer	QT1801	Use with QT1100, QT1101, QT1116, or QT1119 Driver Handle.
Countershaft Support	QT2006	Use to support front of countershaft when installing countershaft rear bearing
1-2 Synchronizer Support	QT2008	Use to support 1-2 synchronizer hub during synchronizer assembly
10mm 1/2″ Drive 12 Point Socket	QT1020	USA Made Impact Socket for Factory Tailshaft Housing Bolts
Long Shank Punch for Shift Lug	QT9300	3/16″ x 8″ Shank for 5th Gear Shift Lug Roll Pin