AMPS-Compatible Dash Mount 20082017 Toyota Sequoia

This dash mount is engineered to fit the 20082017 Toyota Sequoia and is compatible with AMPS standard attachments. Its the perfect solution for securely mounting phones, tablets, dash cams, CBs, radios, and moregiving you a clean, factory-style setup with no drilling required.

Kit Includes:

• CNC laser-cut dash mount with fine black textured powder coat finish
• (5) M6 stainless steel hex socket cap screws
• (3) Stainless steel fender washers
• (2) Steel rectangular washers
• (5) M6 stainless steel nylon lock nuts
• Lifetime warranty against manufacturing defects and workmanship

California Residents: WARNING Cancer and Reproductive Harm
Optional: Dual QC 3.0 USB charger available

Before You Buy:

• Installation requires removal of the 12V socket trim, A/C controls, and radio
• No drilling required
• If your Sequoia has a center dash speaker, it must be removed or relocated under the dash if your mounts (e.g., RAM) make contact
• Factory speakers are bolted from the topwe recommend using 1/2 screws for any reinstallation
• Buyer assumes all risk of modification. ICS Fab is not responsible for injury or property damage from incorrect installation

Installation video coming soon.
Tip: Pre-install your mounts (RAM, etc.) on the dash plate before starting installation.

Tools Required:

• 5mm Allen wrench
• 10mm socket
• Long extension
• Ratchet
• Trim removal tools

Installation Steps:

1. Use trim tools to remove the center dashboard speaker cover.
2. Install your preferred mounts (e.g., RAM) on the dash mount in your desired layout.
3. Insert the five provided screws through the dash mount and test-fit it on the dash. Ensure no mount hardware interferes with the dashboard.
4. Pull out the lower 12V socket trayno need to unplug, just lay it aside.
5. Remove trim around the A/C fan speed knob and pull out the A/C control panel. Set it aside.
6. Remove the four 10mm bolts securing the radio. Disconnect the antenna cable and lay the radio aside.
7. Install the dash mount using the provided screws.
8. Attach the fender washers and lock nuts to the three front screws.
9. Attach the rectangular washers and lock nuts to the two rear screws.
10. Tighten all screws hand-tight, then a 1/4 turn more. Do not overtighten.
11. Reassemble the radio and trim components.